Evolis Zenius User's Guide download pdf (Page 51)

Appendix B

B1 - Compliance statements

In this section, you will nd the certications for your Evolis printer.

Compliance statements

Concerning Safety and Electromagnetic Compatibility of Radio

Equipment (R&TTE 1999/5/CE Directive )

Manufacturer name: Evolis Card Printer

Manufacturer address: 14, avenue de la Fontaine

Z.I. Angers Beaucouzé

49070 Beaucouzé, France

Equipment name: Zenius

Year of manufacture: 2011

I, the undersigned,

Serge Olivier,

Declare under my own responsibility, that the product described above

complies with the essential applicable requirements of the 1999/5/CE

directive:

Article 3.1 b: (electromagnetic compatibility protection requirement)

Safety standard applied EN60950-1:2006 + A11

EN50364:2001

EN62311:2008

Article 3.1 b: (electromagnetic compatibility protection requirements)

EMC standard applied EN55022:2006 + A1

EN55024:1998 + A1 + A2

EN61000-3-2:2006

EN61000-3-3:2008

EN301489-3:V1.4.1

Article 3.2: (Good use of the radio frequency spectrum to avoid undesirable interferences)

EMC standard applied EN302291-2 V1.1.1

Full name: Serge Olivier

Position: R&D Director

Date: 2011

Signature:

EUROPE - Norway Only: This product is designed for IT power system with phase-

to-phase voltage 230V. Earth grounding is via the polarized, 3-wire power cord.

FI: “Laite on liitettävä suojamaadoitus koskettimilla varustettuun pistorasiaan”

SE: “Apparaten skall anslutas till jordat uttag”

NO: “Apparatet må tilkoples jordet stikkontakt”

FCC Federal Communications Commission notice

Radio frequency interference in the United States

The Zenius model complies with the following specication: FCC Part

15, Subpart A, Section 15.107(a) and Section 15.109(a) Class B Digital

device.

Additional information:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can

be determined by turning the equipment off and on, the user is encouraged to try the following measures:

- Reorient or relocate the receiving antenna.

- Increase the distance between the equipment and the radio or television.

- Connect the equipment to a circuit other than that to which the receiver is connected.

- Consult the supplier or an experienced radio/TV technician.

Use of a shielded twisted pair cable is necessary to comply with the restrictions laid down by part 15 of the

FCC Rules for Class B digital devices.

Pursuant to Part 15.21 of the FCC Rules, any changes or modications made to this equipment without

the express, written consent of Evolis Card Printer may cause harmful interference and void the FCC

authorisation to operate this equipment.

It is recommended to respect a distance of 20 cm between user and RFID module when the module is

powered.

Japanese radio frequency interference (VCCI)

This equipment is Class B information technology equipment based on the rules

laid down by the Voluntary Control Council For Interference by Information

Technology Equipment (VCCI). Its use in or close to a residential area may

cause radio interference, in which case, you must take appropriate steps.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 62 63

Comments to this Manuals

No comments

Evolis Zenius User's Guide Page 51

Comments to this Manuals

Related products and manuals for Print & Scan Evolis Zenius